Servo de Rotação Contínua - FS5103R

This servo rotates fully forward or backward instead of moving to a position. You can use any servo code, hardware, or library to control these servos. Good for making simple moving robots. Comes with four different horns, as shown.

To control with an Arduino, we suggest connecting the control wire to pin 9 or 10 and using the Servo library included with the Arduino IDE. Position "90" (1.5ms pulse) is stop, "180" (2ms pulse) is full speed forward, "0" (1ms pulse) is full speed backward. They may require some simple calibration, simply tell the servo to 'stop' and then gently adjust the potentiometer in the recessed hole with a small screwdriver until the servo stops moving.

Note: This product no longer includes the hole to adjust the Zero point.

Technical Details

Details:

Operating Voltage: 4.8V~6V (5V works best)
Average Speed: ~0.18sec/60°
Stall Torque (4.8V): 3kg.cm/41.74oz.in
Stall Torque (6V): 3.2kg.com/44.52oz.in
Required Pulse: 500us-2500us
Connector Wire Length: 30cm / 11.8"
Dimensions: 37mm x 54mm x 20mm / 1.5" x 2.1" x 0.8"
Weight (no horns): 40g
Spline Count: 25