FT2232D-REEL - Interface Bridges, USB to UART, FIFO, 3 V, 5.25 V, LQFP, 48
Descrição geral do produto
Single chip USB to dual channel serial/parallel ports with a variety of configurations
Entire USB protocol handled on the chip. No USB specific firmware programming required
Transfer Data Rate 300 to 3Mbaud
USB to parallel FIFO transfer data rate up to 1 megabyte/second
Multi-Protocol Synchronous Serial Engine (MPSSE) to simplify synchronous serial protocol design
CPU style FIFO interface mode simplifies CPU interface design
FTDIs Virtual Com Port and Direct drivers eliminate requirement for USB driver development
Highly integrated design includes 3.3V LDO regulator for USB I/O
Integrated POR function and on chip clock multiplier PLL (6MHz-48MHz)
Asynchronous serial UART interface option with full hardware handshaking and modem interface signals
Enhanced bit-bang Mode interface option with RD# and WR# strobes
Configurable I/O drive strength
Fully assisted hardware or X-On/X-Off software handshaking
UART Interface supports 7/8 bit data, 1/2 stop bits, and Odd/Even/Mark/Space/No Parity
Configuration mode and USB Description strings configurable in external EEPROM over USB interface
Supports bus powered, self powered and high power bus powered USB configurations
Low operating and USB suspend current
UHCI/OHCI/EHCI host controller compatible
USB 2.0 Full Speed (12Mbits/Second) compatible
Aplicações
Communications & Networking, Consumer Electronics, Multimedia, Portable Devices
Informação do produto
Bridge Type: USB to UART, FIFO
Supply Voltage Min: 3V
Supply Voltage Max: 5.25V
Interface Case Style: LQFP
No. of Pins: 48Pins
Operating Temperature Min: -40°C
Operating Temperature Max: 85°C
Product Range: USB to UART Interface
Automotive Qualification Standard: -
MSL: MSL 3 - 168 hours